تحليل أداء خوارزميات فك التشفير المرنة المختلفة لرموز NR-LDPC Performance Analysis
محتوى المقالة الرئيسي
الملخص
Channel coding technique is a fundamental building block in any modern communication system to realize reliable, fast, and secure data transmission. At the same time, it is a challenging and crucial task, as the data transmission happens in a channel where noise, fading, and other impairments are present. The Low-Density Parity-Check (LDPC) codes give substantial results close to the Shannon limit when the complexity and processing delay time are unlimited. In this paper, the performance of the LDPC decoding with four algorithms was investigated. The investigated four algorithms were Belief Propagation (BP), Layered Belief Propagation (LBP), Normalized min-sum (NMS), and Offset min-sum (OMS). These algorithms were examined for code rates ranging from 1/3 to 9/10 and message block lengths (64, 512, 1024, and 5120) bits. The simulation results revealed the flexibility of these decoders in supporting these code rates and block lengths, which enables their usage in a wide range of applications and scenarios for fifth-generation (5G) wireless communication. In addition, the effect of the maximum number of decoding iterations on the error correction performance was investigated, and a gain of 5.6 dB can be obtained by using 32 decoding iterations at BER=2*10-3 instead of one decoding iteration. The results showed that the decoders performed better for longer message blocks than for short message blocks, and less power was required for transmitting longer messages. Finally, the comparison results of their performance in terms of bit error rate (BER) under the same conditions showed a gain of 0.8 dB using LBP at BER= 10-5 compared with the NMS decoding algorithm.
تفاصيل المقالة
القسم

هذا العمل مرخص بموجب Creative Commons Attribution 4.0 International License.
THIS IS AN OPEN ACCESS ARTICLE UNDER THE CC BY LICENSE http://creativecommons.org/licenses/by/4.0/
المراجع
Garlock M, Payá-Zaforteza I, Kodur V, Gu, L. Fire Hazard in Bridges: Review, Assessment and Repair Strategies. Engineering Structures, Elsevier, 2012; 35: 89-98.
Kodur VKR, Aziz EM, Dwaikat MMS. Evaluating Fire Resistance of Steel Girders in Bridges. ASCE Journal of Bridge Engineering, 2013; 18: 633-643.
Reis A, Lopes N, Vila Real P. Numerical study of steel plate girders under shear loading at elevated temperatures. Journal of Constructional Steel Research, 2016; 117:1-12
Kang MS, Kang JW, Kee SH, Choi BJ. Damage Evaluation of Composite Beams under Fire Conditions. International Journal of Steel Structures, 2020; 20: 1996–2008.
Alexander A, Clifford L, Bala T. Experimental Investigation of the Ultimate Shear Resistance of End Web Panels in Steel Girder Bridges. Canadian Journal of Civil Engineering, 2009; 36(2):267-279.
Payá-Zaforteza I, Garlock MEM. A Numerical Investigation on the Fire Response of a Steel Girder Bridge. Journal of Constructional Steel Research, 2012; 75: 93-103.
Vimonsatit V, Tan K, Qian Z. Testing of Plate Girder Web Panel Loaded in Shear at Elevated Temperature. Journal of Structural Engineering, 2007; 133(6): 815- 824.
Kodur VKR, Fike RS. An Approach for Evaluating the residual strength of fire-exposed RC beams. Magazine of Concrete Research, 2010; 479-486.
Choe L, Ramesh S, Zhang C, Gross J. The performance of structural steel beams subject to a localized fire. 9th International Conference on Structures in Fire 2016b; Princeton, New Jersey, USA.
Naser MZ. Response of Steel and Composite Beams Subjected to Combined Shear and Fire Loading. Ph.D Thesis, 2016, Michigan State University.
Ramesh S, Seif M, Choe L. Localized fire tests on steel beams with different end restraints. 9th International Symposium on Steel Structures, 2017 November 1-4, Jeju, Korea
AISC (2013). Steel Construction Manual. 15th Edition. American Institute of Steel Construction, Chicago, Illinois.
ASTM E119a (2008). Standard Methods of Fire Test of Building Construction and Materials. American Society for Testing and Materials, West Conshohocken, PA.
Nguyen XT, Park JS. Nonlinear buckling strength of steel H-beam under localized fire and pure bending. KSCE Journal of Civil Engineering 2021; 25: 561–573.
Segui William T. Steel Design. Global Engineering: Christopher M. Shortt, 5th, 2013, USA.
McCormac J and Csernak S. Structural Steel Design. Pearson, 5th Edition, 2011.